This panel shows all configured devices. Here you can see which devices are slow and control the enable state of each device. It is possible to see how many items are published for each device, helping optimization attempts on particular devices.

Device List

When selecting a device, it is possible to see it's information on the Device Panel. This panel shows the following data:

Device description: On the top of the panel (the above image display "3Com SuperStack 3" as Device Description).

IP address

Scanned Items: The amount of items scanned in this device.

Scan Time: The time needed to entirely scan this device.

Scan Rate: The refresh rate configured for this device.

Scan Overlap: This text appears only when the scan time is greater than the scan rate, specifying that this device is not configured properly.

Enable Device Scan: Disable this checkbox when it is not important to scan this device at this moment..
 

Device Information

Below the Device Panel exists a list of tags with four columns:

Name: Indicates the device name.

Value: Indicates the device value just in time.

Timestamp: Indicates when the last value have been collected.

Quality: Indicates the process quality at time.