XRatel FAQ

[ General | IT Health OPC Server | Server Config | OPC Server Monitor ]

       XRatel OPC Server Monitor

Q: What is XRatel OPC Server Monitor?

A: XRatel OPC Server Config is used to connect to XRatel OPC Servers, collecting real time data from the configured probes. Using XRatel OPC Server you can check probes values, verify OPC groups, export probes to an CVS file and connect to an remote XRatel OPC Server. See more.

Q: Can I connect to a remote XRatel OPC Server?

A: Yes you can. Use Connect to a new Server button and OPC Server Scan will open. Using it you can look for a server on a single host (Scan By Host) or you can scan your whole network using an IP Range (Scan By IP Range). After that, just choose the server and click on Connect. Note that you must have administrator privileges on the host for connection.

Q: What do "Bad Limit" means?

A: "Bad Limit" means that XRatel Monitor could not collect data from the OPC Server. Check if the monitored device is on or if the configuration is OK.

Q: How can I connect with more than one XRatel OPC Server at the same time?

A: You just have to click on Connect to a new Server button. It will open in another tab.