Using XRatel Server Config

[ Main Window | Scan Devices | Device Config | Group Settings | Probes | Probe View Settings | Profile Management |

Report Config | Alarm Config | MIB Management | License and Activation ]

       Predefined Probes Config

The Predefined Probes are formatted Probes calculated from Raw Probes. XRatel Server Config can automatically detect all needed Raw Probes and configure them for you. All Predefined Probes are calculated in server, being unnecessary client configuration. All supported Probes are listed below:

SNMP Predefined Probes

Interface Utilization: Interface percentual utilization. Computed using the interface speed and total communication (input/output)in bytes.

Interface Effectiveness: Percentual volume packets discarded because of errors. Indicates the ratio between discarded packets and Interface Packet Rate.

Interface Link State: Indicates the status of the interface. 0 indicates that this interface is inactive while 1 indicates that is active. 2 indicates that the interface is on test.

Interface Unicast Rate: Percentual volume of unicast packets. Ratio between sent and received unicast packets and Interface Packet Rate probe.

Interface Non Unicast Rate: Percentual number of sent and received broadcast and multicast packets. It is a ratio calculated using Interface Packet Rate probe.

Interface Packet Rate: Total number of sent and received packets in this interface.

Interface Data Rate: Total traffic data number in bytes. This probe is computed using the total sent and received packets from this interface.

Interface Health: A percentual variable calculated using Interface Broadcast Rate, Interface Link Status and Interface Effectiveness. Each of these probes has an adjust, allowing you to make the best configuration Then, health is computed multiplying all source probes, allowing a unique probe to zero the health.

Interface In Transmitted: Rate of packets received by the interface.

Interface Out Transmitted:  Rate of packets transmitted by the interface.

Interface Download Rate: Rate of data received per second.

Interface Upload Rate: Rate of data transmitted per second.

Interface Speed: Interface max speed.

Interface Type: Interface type. E.g.:Ethernet, Wi-fi, etc.

WMI Predefined Probes

Device Processor: Indicates the percentual CPU Utilization.

Device Hard Disk: Measure the precentual Hard Disk Utilization.

Device Physical Memory: Indicates the percentual physical memory utilization.

Computer Health: Indicates the computer's health based on Processor, Hard Disk and Physical Memory.Each of these probes has an adjust, allowing you to make the best configuration.Then, health is computed multiplying all source probes, allowing a unique probe to zero the health.

Predefined Probes

There are eight columns in Predefined Probes list:

Enable: Indicates if the server scan is active for current Probe.

History: Add this Probe into XRatel Historian Service.

Device: Indicates the device owner of the Probe.

Probe Name: Shows defined Probe name for current Probe.

Probe Type: Informs the type of the Probe.

Probe Description: An explain text for the Probe.

Protocol: Shows the Protocol used to collect the Probe.

IP Address: Indicates the IP Address which the Probe is coming from.

The Probe Properties dialog for Predefined Probes allows you to configure Probe's Name and Description. Health Probe field activates the inclusion of this Probe in device health calculation. This field is available only for Interface Health's Probes.